rainbow butterfly chocolates - how to
creating the butterflies for the rainbow cake and cake pops was great fun.
the good news is that chocolate stores well at room temperature, so you can make the wings well in advance of cake & pop assembly.
be sure not to freeze your chocolate pieces. extreme temps cause the fats in chocolate to bloom, bringing chalky looking crystals to the surface. room temperature storage is always best.
CHOCOLATE CANDY BUTTERFLIES
adapted from Hello Cupcake
candy making squeeze bottles
chocolate candy melts
tinted white candy melts
(should you choose to tint your own, buy white chocolate candy melts and oil-based tints)
index card for drawing your butterfly template(s)
helpful tips for working with chocolate (a cautionary tale):
* don't use chocolate chips--they don't melt as smoothly, and will never fully set. bottom line, they don't work for this project (trust me, I learned the hard way).
* don't let even the tiniest drop of water into your chocolate. ever. any moisture will cause the chocolate to sieze. once that happens, there is no hope. you can use siezed chocolate for baking recipes, but it won't work for candy. (again, speaking from experience)
* if you're tinting your own white chocolate, use oil tints. as noted above, even the smallest amount of water will ruin your chocolate, so water-based colors won't work (yes, yes, I tried this, too)
* don't overheat your chocolate. candy melts don't need much heat to melt to a super smooth consistency, and chocolate that becomes too hot will also become too thick.
* if you over heat your chocolate and it becomes too thick, don't add milk, water, butter, shortening, or any other suggestion you might (ahem) find online. your results will not be candy-friendly. you can, however add paramount crystals which will help to thin your base without ill effects.
*if bakerella uses merckens chocolate, and recommends it, you should follow her advice. I chose a different brand for convenience, and regretted the mistake.
to begin making your chocolate butterflies, fill one bottle with chocolate melts, and one with tinted melts. place bottles in a pan of hot water to melt. take care that no water enters the squeeze bottles--if they come with a cap, use it.
after a minute or two in the hot water, shake your bottles to help disperse heat. repeat as needed until the chocolate is melted to a smooth consistency. keep the hot water handy as you'll need to reheat your chocolate as you go.
alternately, melt your chocolate in a double broiler or in the microwave (taking great care not to overheat) and spoon into sandwich baggies. cut a small hole at the tip of the bag and use to pipe your design.
once your chocolates are melted, you're ready to begin.
lay a large sheet of parchment over a cookie sheet, and slide your template under at one corner. using a steady hand, pipe a chocolate border all around each wing. you want to make sure each wing in an individual candy, so take care they don't connect at any point.
working quickly but steadily, fill in the wings with your tinted chocolate. with a toothpick, push the tinted chocolate all the way to the chocolate border, and swirl together in a couple spots, to create a subtle marbling effect.
while your chocolate wings are still warm, sprinkle a few nonpareils at the tips of the wings, to mimic the patterning of a monarch.
slide your stencil to a new area of parchment, and repeat. allow your wings to set on the parchment paper for an hour or so, then move to an air tight container until ready to use.
for different sized butterflies, simply change the size of your stencil. to mount atop cake pops, I made 1" wings. for the cake, I used three sizes: 1", 2" & 3.1/5" wings.
if you have chocolate left over once you've made your desired quantity, play around on the parchment to create additional design elements for decorating. with the extra tinted chocolate I had from the project, I created rows of polka dots that were later used to decorate the sides of the cake. I used the left-over dark chocolate to make antennae (which I decided not to use, after all).
when you're ready to decorate your cake, melt a fresh batch of the dark chocolate melts. draw a thick line for your butterfly's body, and allow to cool for a few seconds. while still soft, sink the wings into the chocolate body at your desired angle. hold in place until set (a few seconds more). for larger wings, add additional support by tucking a white chocolate morsel beneath each wing.
If you decide to use antennae, add one more drop of chocolate to the head, insert antennae, and hold until set.
to make cake pops, I followed the basic recipe & directions found at bakerella.com
when decorating cake pops with butterflies, draw a small body atop each pop, and insert wings as described above. hold in place until set. as the wings are tiny, you shouldn't need much chocolate to hold them in place.
for added cuteness, drop each cake pop into a vintage paper straw.
last, but not least, find an eager volunteer (or happy assistant) to taste the results for a picture.
kellyallison photography is a chicago area photo studio passionate about the visual documentation of love, life and all things beautiful.
No comments posted.
Recent PostsHistory Museum Wedding elmhurst wedding: ann & eric summer wedding Outstanding in the Field: Dietzler Farms & Hinterland Gastropub--a sneak peek winter beauty photo booth: behind the scenes rainbow butterfly chocolates - how to rainbow butterfly birthday cake - how to rainbow butterfly birthday party it's a party